[blanket rack diy] Can make a unique gift for anyone. Our custom blankets are available in wool, velvet, and other materials.
Begin by cutting the two-by-four in half with a hand sawand miter box. This will give you two four-foot lengths that will serve as the legs to your blanket ladder. Keep in mind this length is approximate. It’s more important that the two pieces are the same length than being exactly four feet, and this gives you the … See moreNext, cut your one-by-three board into four 16' pieces. These will be the slats across your blanket ladder. Sand each slat to ensure they are smooth (so your blankets won't snag and tear). See moreLay out legs and rungs on a flat surface and position like a ladder. On the face of the two-by-fours, measure and mark the position of the rungs. From the “top” of the ladder measure … See morePre-drill with a 3/32” bit inside of the pencil lines and through to the other side of the two-by-four. Be careful to drill straight so as not to break … See morePosition the rungs within the pencil lines, angling them up towards the front and top of the ladder. The corners of the one-by-three should be just touching the pencil lines on either side. The back corner should be flush with the edge of the 2x4, and the front corner … See more
recommended article: